The warm temps made it perfect to fill up my bucket with some sudsy water and give my Jeep a bath. In the salt belt a good washing helps prevent corrosion.
Since I was out in the garage, it was the perfect time to finish up a couple of small projects I couldn't get to because of the winter cold. These two projects should have been quick and easy. However for a Jeep Mom, working on your Jeep never is quick, and not for reasons you may be thinking.
I was constantly interrupted. A dog bark from inside the house meant I needed to go in to let her outside. Then some hungry boys came out in search of mom the cook. I have learned over the years to plan a little extra time for my projects because a mom's work is never done. Okay back to my projects...
These are super easy to add to the door handles. A few simple easy steps:
Drill two marked spots
Secure with screws
At the beginning of 2017 I shared my headlight flicker dilemma.
It was suggested I buy anti-flicker decoders. These decoders will help with the pulse width modulation. So with a pop of the Jeep grille, I switched out the harnesses that came with the lights. Pretty simple swap out. Once the grille is off just unscrew the four screws holding the headlight to the housing. Then unplug the wiring harness to swap with the decoder.
Unplug and plug
Simple and easy